Free system design.
Send any questions.
Victron Phoenix Inverter
• Low battery voltage alarm trip and reset levels
• Low battery voltage cut-off and restart levels, or Dynamic Cut-off
• ECO mode on/off and ECO mode sense level Monitoring Battery voltage, AC Output voltage and current, alarms
Proven reliability The full bridge with toroidal transformer topology has proven its reliability over many years. The inverters are short circuit proof and protected against overheating, whether due to overload or high ambient temperature.
High start-up power Needed to start loads such as power converters for LED lamps, filament lamps or electric tools.
ECO mode When in ECO mode, the inverter will switch to standby when the load decreases below a preset value. It will switch on and check every few seconds, adjustable, if the load has increased again.
Remote on/off connector A remote on/off switch can be connected to a two pole connector or between battery plus and the left hand contact of the two pole connector.
LED diagnosis A red and a green LED indicate inverter operation and status of the different protections.
To transfer the load to another AC source: the automatic transfer switch
For our low power inverters we recommend our Filax Automatic Transfer Switch. The Filax features a very short switchover time (less than 20 milliseconds) so that computers and other electronic equipment will continue to operate without disruption.
A brighter future. Off the grid. Iron Edison battery systems can be used for 12, 24 and 48 volt applications. We can also help you optimize battery capacity to take better advantage of the solar, wind and other hardware you may already have in place.