Free system design.
Send any questions.
The Conext™ Configuration tool is used by system installers to simplify the task of system configuration and reduce installation time. It’s a PC-based software tool that works on systems that include the Conext™ XW Pro, XW+, SW, and peripherals.
The Conext Configuration tool is not meant to replace the Conext™ System Control Panel (SCP), Conext™ Gateway, ComBox or any other monitoring devices. Those monitoring devices may still be required to monitor the Conext System and components.
Software and drivers for the Conext Configuration Tool are under the downloads section (Firmware).
Conext Config USB Driver is firmware used for general installation setup.
Conext Config Tool Software_AI (Anti-Islanding) is used when 2 or more inverters are installed in parallel on a single phase connection (See Conext XW+ Multi-Unit Power System Design Guide under the downloads section (Technical Publications). It is also used if there is a specific requirement by a utility.
Note: Adjustment of AC anti-islanding parameters should only be done after consultation with the power utility or authority having jurisdiction.
Note: The configuration tool should not be used with Conext Gateway/ComBox in-network especially when performing Firmware Upgrades. Use either the Conext Gateway/ComBox or the configuration tool to complete firmware upgrades – but not both.
starting from $599.98
Free solar + battery system design
Installer network across the USA
Free installation support
Lifetime technical support
Iron Edison is owned and operated by Brandon and Maggie Williams. They have three children, and live and work in Colorado.
Brandon and Maggie believe in energy independence and for the past 10 years they have helped thousands of people achieve their goal of powering their homes with batteries and solar. We love working everyday with our customers and we hope you decide to choose Iron Edison for your battery and solar needs.