Iron Edison

Clean Energy Storage for a New Generation

Need Help? Call 720-432-6433

MidNite Solar / MidNite Solar Lightning Arrestor and Surge Protection Device (SPD)

Configure this product

Item added to order

The MidNite Solar Surge Protector Device is designed for both AC and DC systems

Recommended for protecting a inverter, charge controller, and solar system against EMP or Electro Magnetic Pulses from solar flares or other sources.  

LED shows if fuse has blown or if SPD is functioning.  Clamping voltage as low as 385 V.    

The MidNite Solar Surge Protector (MNSPD) is a Type 2 device. It is designed for both AC and DC systems and provides protection to service panels, load centers or where the SPD is directly connected to the electronic device requiring protection. Maximum protection will only be achieved if the SPD is properly installed. The MidNite Solar SPD is offered in three different voltages to maximize the required protection level. Protection is achieved by reducing the clamping voltage to a safe voltage that your system can sustain without damaging any electronics in the system. The MidNite Solar SPD voltage rating should be chosen according to the nominal voltage of the system. Response time is 8/20µs to clamp 128,000 amps. There are two LED's in each unit that will indicate when the unit is functioning correctly and there is voltage to it.

Install the 150V DC version for surge protection on wires coming from a 12, 24, or 48v PV array, DC wind generator or DC hydroelectric turbine, the 300VDC unit for DC sources up to 300v, and the 600VDC unit for high-voltage grid-tie PV arrays. Lightning protection can be installed in a combiner box, DC load center or grid-tie inverter. They can be used on your AC load center to protect your equipment from surges from the utility lines and on AC wiring running outside of the building, to generators, pumps or outbuildings. Mounts easily in a 1/2" knockout. Material and workmanship warranty for 5 years.

Check out this great video by MidNite Solar:

call Iron Edison 720-432-6433

Give us a call
We are happy to help!

or email Info@IronEdison.com

The Last Battery you’ll Ever Buy.

Over a century ago, Thomas Edison found a battery design that he considered to be nearly perfect. Today, Iron Edison is proud to offer an updated version of this incredible design that is specifically manufactured for Renewable Energy systems.

An Iron Edison Nickel-Iron Battery
  • Refillable alkaline electrolyte
  • Large storage capacity (up to 48 kWh)
  • Full depth of discharge
  • 12, 24 and 48 Volt applications
  • Nearly indestructible

Iron Edison now offers a full line of solar panels, charge controllers, inverters and more!

For more information on the advantages of Iron Edison batteries and on our company, check out our About page. Technical specifications and operating procedures can be found in our Reference Library.

A brighter future, off the grid.

A brighter future. Off the grid. Iron Edison battery systems can be used for 12, 24 and 48 volt applications. We can also help you optimize battery capacity to take better advantage of the solar, wind and other hardware you may already have in place.

forever stamp
    ×

    Learn More